- TOP
- Bending Solutions
- Spec.
Wing Bend WB120/230/350-A
Specification |
---|
WB120-A | WB230-A | WB350-A | ||
V Width mm | Equal to V6 | Equal to V10 | Equal to V15 | |
Thickness mm |
Mild Steel | 0.5~1.2 | 0.5~2.3 | 1.0~3.2 |
Stainless Steel | 0.5~1.0 | 0.5~2.0 | 1.0~3.0 | |
Aluminum | 0.5~1.0 | 0.5~2.0 | 1.0~3.0 | |
Min. Angle | 80° | |||
Tool Length mm | 50,100,200 | |||
Tool Width mm | 12 | 22 | 35 | |
Tool Height mm | 80 | 80 | 80 | |
Allowable Tonnage | 1000kN/m | |||
Holder | FEAT AFH Die Holder | ○ | ○ | ○ |
Reversible 1V Die Holder | ○ | ○ | ○ | |
Special Die Rail | × | × | × |
*Please operate with direct mode if machine has NT control.
*Bending Elongation Value of Wing Bend is different from of V Bending slightly. Actual bending check is required. (Please refer to “Reference Bending Data” about reference data.)
*Black coating layer will peel off from outer shoulder radius first because of the characteristic.